Freshly sealed parking lot with new white stall stripes and cones around landscape islands.
Parking lots & commercial

Slurry seal for commercial parking lots

For retail, office, and industrial lots in the Portland metro and SW Washington. Slurry seal specialists since 1987.

Protect the asphalt you already have

If you manage a retail, office, or industrial lot, slurry seal is a way to protect the asphalt you already have — fill in lost fines, cover oxidation, and put down a new wearing surface — without a full overlay.

Blackline Inc. has specialized in slurry seal since 1987. We apply slurry with automated equipment and a laboratory mix design, the same approach used on public pavement. Private and commercial lots we have worked on include sites for Lowe’s, Safeway, Walmart, and Vancouver Mall.

Freshly sealed and striped parking aisle in front of a Lowe’s store.
Lowe’s parking lot, Vancouver.

Built as a wearing surface, not just a coating

Parking lots take turning traffic, sun, and weather. A thin seal coat can darken the pavement for a time. Slurry seal is a mixed product — emulsion plus aggregate — placed as a new surface.

Type I is often used to protect newer lots. Type II is the most common choice once a lot has started to ravel or oxidize. We will recommend a type from the condition of your pavement, not from a one-size-fits-all pitch.

Bank parking lot mid-job, with fresh slurry on one side and worn asphalt on the other.
Halfway through a commercial lot: new slurry on the left, worn asphalt on the right.

Slurry seal is not seal coat

If you were quoted a cheap “seal coat,” ask whether it is actually slurry seal: mixed with aggregate, placed with a slurry machine, and built to a mix design. If it is not, you are not getting the same treatment.

Seal coat

  • A thin coating brushed or sprayed onto asphalt
  • Can darken the surface for a while
  • Not applied with slurry equipment

Slurry seal

  • Asphalt emulsion, aggregate, fillers, and water
  • Mixed on site in an automated machine to a laboratory mix design
  • Fills in lost fines and leaves a new, durable wearing surface
  • Type I, II, or III: a minimum of 1/8", 1/4", or 3/8" of new surface
Full slurry vs. seal coat comparison →

How it works

  1. Request a quote

    Use the quote form and choose “Commercial parking lot.” Include the city, a rough size (square feet or number of stalls — “not sure” is fine), and a photo if you have one.

  2. We follow up

    We’ll get back to you at the number or email you leave, and recommend a slurry type based on the condition of your pavement.

  3. Slurry goes down

    The slurry is mixed on site in an automated machine to a laboratory mix design and placed from a spreader box as a new wearing surface.

  • Since 1987Slurry seal specialists in the Northwest
  • Licensed, insured & bondedIn Washington, Oregon, and Idaho
  • Contractor licensesWA Lic # BLACKI*135CP · OR CCB 66384 · ID PWCL 009681-B-4

Get a parking lot quote

Tell us where the lot is and roughly how big it is. We’ll follow up at the number or email you leave.

Licensed, insured, and bonded. Quote requests go straight to Cody Lorenzen, President. Also see our work with HOAs and our project photos.